Product Name: 3D printer ENDSTOP mechanical limit switch ramps 1.4
Length, width and height: (129.4mm * 88.9mm * 1.6mm)
Weight: 11.4g
Item Type: Switch
Application: 3D Printing
Customized with high quality wire, it can be resistant to 2A and 300V voltage. Insulation is very wide temperature range(it can reach 80 degrees), which is much better than the ordinary thin copper wires.
Not easy to pull off, while plug is convenient.
Mechanical limit switch Schematic
Analytical principle
1 end: power supply (VCC)
2 end: ground (GND)
3 end: connect with 2
4 end: Signal

Package Type:
All goods will pack into cartons and wrapped full of waterproof tape before shipment .

We can accept customized package to meet different requirements :
1.Every item will separately pack into plastic bag ,component, module can be packed in anti static bag .
2.Some fragile products such as the display screen can be packed in bubble bag .
3.Some large machines can be packed in wooden cases.
4.We can label JH code or client's code on package so that customers can check easily after receive goods.